Changes to Step #4
Edit by Christopher Howell —
Edit approved by Christopher Howell
- Before
- After
- Unchanged
Step Lines
| [* black] Mount OpenEVSE Plus board with 5/8" screws from the top. | |
| - | [* icon_reminder] Place nylon spacers between OpenEVSE board and mounting plate. Tighten Lock washers from the bottom. Do not over tighten. |
| - | [* black] h |
| + | [* icon_reminder] Place nylon spacers between OpenEVSE board and mounting plate. Tighten Lock Nuts from the bottom. Do not over tighten. |
| + | [* black] Mount Ground block with 2 - 3/4" screws from the bottom. Tighten Lock nuts from the top. |
| + | [* icon_caution] Connect OpenEVSE Ground to the ground Block. Ensure connections are secure. |
| + | [* black] Crimp Yellow connector to 10AWG wire. Screw to the Fuse block. |
| + | [* icon_caution] Ensure crimps are secure. Do not solder connectors designed for crimping. Do not connect and disconnect terminal. If loose, discolored, or damaged replace immediately. |
Image 2
Old Version
New Version
Image 3
Old Version
New Version