Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by Christopher Howell

Edit approved by Christopher Howell

Before
After
Unchanged

Step Lines

[title] Connect Wifi Module to OpenEVSE board
-[* black] 1) Connect the ***Red (+) lead ***of UBEC Power module to the +12v header labeled ***RELAY 1/2 Common ***. Connect the Black (-) lead to Ground.
+[* black] 1) Connect the ***Red (+) lead ***of UBEC Power module to the +12v header labeled ***RELAY 1/2 Common ***. Connect the Black (-) lead to the Ground Block.
[* black] 2) Connect the power and data header (4 of 6 wires) to the Wifi Module.
[* black] ***Pin 1*** - Ground (Black) ***Pin 3 ***- 5v (Red) - 75ma max (higher power devices must use external power.) ***Pin 4 ***- Recieve (Yellow) connects to transmit on the remote device. ***Pin 5 ***- Transmit (Green) connects to receive on the remote device.
[* black] 3) Connect the data only header (2 of 6 wires) to the OpenEVSE Board.
[* black] ***Green to RX ***, ***Yellow to TX *** (++TX on WiFi goes to RX on board, RX on WiFi goes to TX on board++)
[* black] 4) Mount the WiFi unit by using an alcohol pad to clean the enclosure at the desired mount location. When dry remove the plastic on the high temp industrial double sided tape and attach the WiFi module to the enclosure.

Image 1

Old Version

New Version