Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #3

Edit by Travis F

Edit approved by Christopher Howell

Deleted
Added
Unchanged

Step Lines

[title] Mounting Plate
[* icon_caution] If your kit contains a Packard C240C contactor, continue here. [guide|8|Guide]
[* black] Figure out the orientation of the plate by placing the OpenEVSE controller and bus bar over the plate. Optional: if you wish to pretty up the plate, use a green scotchbrite pad on it. Wipe clean afterward.
[* black] Mount hex standoffs to the top side of the plate with 6 mm screws.
[* black] Mount ground bar to the plate with 2 - 5/8" self threading screws. Note: Use the kit screws, not the screws from the ground bar package.
[* black] Mount ground bar to the plate with 2 - 5/8" self threading screws. Note: Use the kit screws, not the screws from the ground bar package.
[* black] Mount the Struthers & Dunn relay using 2 - 1/2" self threading screws.
[* black] Mount OpenEVSE controller to the hex standoffs with 6mm screws.