Changes to Step #8

Edit by Christopher Howell

Edit approved by Christopher Howell

Before
After
Unchanged

Step Lines

[title] Controller Wiring
[* icon_caution] View OpenEVSE v5 Diagram in previous step for wires named below.
-[* red] Connect both keyed wiring harnesses to OpenEVSE controller.
+[* red] Connect the keyed wiring harnesses to OpenEVSE controller.
[* icon_note] Wire colors may vary.
-[* orange] Connect [guide|26|DC Relay 1 GND|stepid=157] (Black) to the bottom middle coil terminal. Tighten screw.
-[* light_blue] Connect [guide|26|DC Relay C +12v|stepid=157] (Red) to the top middle coil terminal. Tighten screw.
-[* black] Connect [guide|26|AC INPUT 1|stepid=157] to the bottom left power terminal. Start screw, but leave loose additional power wire added later.
-[* red] Connect [guide|26|AC INPUT 2|stepid=157] to the top left power terminal. Start screw, but leave loose additional power wire added later.
-[* yellow] Connect [guide|26|AC_TEST 1 and 2|stepid=157] to the top and bottom right power terminals. Start screw, but leave loose additional power wire added later.
+[* green] Connect the WiFI data cable to the controller wit the green wire closest to the board edge.

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

Old Version

New Version