Changes to Step #8

Edit by Travis F

Edit approved by Christopher Howell

Before
After
Unchanged

Step Lines

[title] Controller Wiring
[* icon_caution] View OpenEVSE v5 Diagram in previous step for wires named below.
[* red] Connect both keyed wiring harnesses to OpenEVSE controller.
[* icon_note] Wire colors may vary.
-[* orange] Connect [guide|26|DC Relay 1 GND|stepid=157] (Black) to the bottom middle coil terminal.
-[* light_blue] Connect [guide|26|DC Relay C +12v|stepid=157] (Red) to the top middle coil terminal.
-[* black] Connect [guide|26|AC INPUT 1|stepid=157] to the bottom left power terminal
-[* red] Connect [guide|26|AC INPUT 2|stepid=157] to the top left power terminal.
-[* yellow] Connect [guide|26|AC_TEST 1 and 2|stepid=157] to the top and bottom right power terminals.
+[* orange] Connect [guide|26|DC Relay 1 GND|stepid=157] (Black) to the bottom middle coil terminal. Tighten screw.
+[* light_blue] Connect [guide|26|DC Relay C +12v|stepid=157] (Red) to the top middle coil terminal. Tighten screw.
+[* black] Connect [guide|26|AC INPUT 1|stepid=157] to the bottom left power terminal. Start screw, but leave loose. Screw will have additional power wire added to it at a later step.
+[* red] Connect [guide|26|AC INPUT 2|stepid=157] to the top left power terminal. Start screw, but leave loose. Screw will have additional power wire added to it at a later step.
+[* yellow] Connect [guide|26|AC_TEST 1 and 2|stepid=157] to the top and bottom right power terminals. Start screw, but leave loose. Screw will have additional power wire added to it at a later step.