Mount the water resistant button switch to the enclosure lid. Do not over tighten seal, if squeezes out of place the button is too tight.
Test enclosure lid again for water tightness. Spray water around the LCD window and button and ensure water does nor leak to the back side of the lid. Adjust as necessary.
Using 4 - 5/16" wide head screws. Mount LCD module to the lid.
Screws should be secure. Take care not to over tighten.
Connect the 3 pin cable to the LCD module. Strip wires about 1/2", fold in half stripped wire and screw into the switch screw lugs.
Connect 4 pin connector to LCD note the color that represents Ground (Green as pictured).
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.