Connect J1772 cable gland to the enclosure base.
Run both HOT lines through the GFCI coil.
Connect J1772 Hot lines to relay outputs.
Connect the 22AWG wires from the QC connectors on the J1772 cable to the "AC Test - H" and "AC Test - N" to the OpenEVSE board.
Connect J1772 Ground to Ground block
Connect the Control Pilot from the J1772 cable to the OpenEVSE board.
Each manufacture uses different color codes for pilot. IT/Leviton - Orange, Yasaki - Blue, Quick Charge Power - Purple.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.