If your kit contains a Packard C240C contactor, continue here. Guide
Mount hex standoffs to the top side of the plate mounting plate with 4 - 6 mm M2.5 screws. Mount the OpenEVSE board to the hex standoffs with the other 4 - 6mm M2.5 screws.
Mount Ground bar header block to the mounting plate from the top using 2 - 5/8" self threading screws.
Do not over tighten the self threading screws. tighten until secure. Use of a non powered Screw driver is recommended.
Mount the Struthers - Dunn contactor using 2 - 1/2" self threading screws.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.