Power ON. Use caution.
A OpenEVSE programmer can be used to power the controller to adjust contrast. Note there will be errors (this is normal) as not all systems are powered.
Adjust LED contrast (VR-1) if text is not visible. Be very careful not to touch any while powered.
When adjusting, be gentle. Do not force past the stop in either direction. If forced past the stop, the part will no longer function.
Secure the enclosure lid. Tighten the screws slowly alternating across and top, middle and bottom.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.