Using 4 - 6mm screws. Mount display module to the lid.
Connect 4 pin connector to display module.
Note the color that represents Ground (Black as Pictured)
Connect the 3 position connector (2 wires attached) to the display module and the ends to the button.
Mount WiFi to the left of the button with the header pins to the far left.
Flip lid over and tighten screws to fully the compress the watertight foam seal.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.