Position the plate with the FOUR holes for the OpenEVSE controller up top-left.
Mount the FOUR 4.5 Hex x 10mm standoffs to the top side of the plate with FOUR M2.5 x 6 mm screws.
Tip - use blue LOCTITE on each screw to ensure it remains tight.
Mount the Struthers-Dunn relay using TWO 1/2" self threading screws.
Mount ground bar to the plate with ONE washer and ONE 1/4" self threading screws.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.