If your kit contains a Struthers and Dunn relay, continue here. Guide
Position the plate with the 4 holes for the OpenEVSE controller up top and the Earth Ground bus bar on the right.
Mount hex standoffs to the top side of the plate with 6 mm screws.
Mount ground bar to the plate with 2 - 5/8" self threading screws.
Note: The screws from the ground bar packaging are not used.
Mount the Packard relay using 4 - 1/4" self threading screws.
Mount OpenEVSE controller to the hex standoffs with 6mm screws.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.