Remove the insulation on all the RED and BLACK power wires.
Insert the power pin on the BLACK wire(s) and crimp.
Insert the power pin in the RED wire(s) and crimp.
Note the power pins are different from the ground pin. Note the smooth surface along the crimp area where the wire is inserted.
Crimp Power pins with Pico Corporation 400B pneumatic crimping tool at 80PSI.
Recommended Die Pico 414DA-8N
Recommended locator - OpenEVSE J1772 Power/Ground
Soldering the pins is possible but requires a lot of heat to get solder to flow throughout. Crimping is recommended.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.