Insert the signal pin on the PURPLE wire and crimp.
Insert the signal pin on the WHITE wire and crimp.
Crimp Ground pin with Pico Corporation 400B pneumatic crimping tool at 80PSI.
Recommended Die Pico 414DA-12N
Recommended locator - OpenEVSE J1772 Signal
Soldering the pins is possible but requires a lot of heat to get solder to flow throughout. Crimping is recommended.
Slide up the pin guide onto the pins.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.