Place the 4 - 10mm M2.5 screws through the top of the enclosure.
Flip lid upside down and stack as follows: Foam seal, then LCD clear window (remove protective coating from both sides).
Note: Kits shipped before February 2018 also include a LCD brace. Install the brace on top of the LCD window.
Kits shipped February 2018 and later include a 1/4" thick LCD window and do not require the brace.
Place the (4) - 10mm M2.5 screws through the lid with the foam washer on the outside. Compress foam and thread the (4) - Hex Standoffs. Tighten each one hand tight, compressing the foam.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.