Skip to main content
Help
/

Site Navigation

Your Account

Choose Language

Editing Step 2 —

Step Type:

Drag to rearrange

Mount the water resistant button switch to the enclosure lid, rubber seal on the outside. Do not over-tighten seal. If it squeezes out of place, the button is too tight.

Test enclosure lid for water tightness. Spray water around the LCD window and button, ensuring that water does not leak to the back side of the lid. Adjust as necessary.

Using (4) - 6mm M2.5 screws, mount LCD module to the lid.

Screws should be secure. Take care not to over-tighten.

Connect the 3-pin cable connector to the LCD module. Strip wires about 1/2", fold in half stripped wire and screw into the switch screw lugs.

Connect the 4-pin connector to the LCD. Note the color that represents the ground wire (green in picture).

Optional - Insert a CR1220 or CR1225 coin cell into the battery holder. If using charging station timers this will keep time during power outages.

Your contributions are licensed under the open source Creative Commons license.