Connect J1772 cable gland to the enclosure base.
Run both HOT lines through the GFCI coil. Connect GFCI cable to the G_CT header. Black wire closest to the board edge.
Connect J1772 Hot lines to relay outputs.
Connect the AC_Test leads to the OpenEVSE board AC_Test header.
Connect J1772 Ground to Ground block
Connect J1772 Pilot wire to the OpenEVSE board pilot terminal. See diagram in Step 3.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.