Drill a hole (up to 1/4") in the bottom left of the enclosure leaving at lease 1/2" inch from the edge of the graphics.
Mount the LED logic board to the laser cut plate with the LED facing down so the LED will shine through the plate.
Screws should be recessed into the plate.
Place the spacer between the plate and LED and the nylon lock nut on top.
Bond the Assembly with watertight, high temperature adhesive such as Epoxy (Best) or Shoegoo E6000 to the enclosure lid so the LED lines up with the hole and the hole is completely covered by the plate.
Ensure good coverage of the adhesive on the plate to create a watertight seal.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.