It would be nice to have a board revision # printed on the board itself. Perhaps it’s on the underside? But that’s not visible anymore since the board was installed in the previous step.
I have a February 2018 kit (shipped Feb 2, 2018) and it includes the LCD brace and foam washers. The screw heads are a different style than pictured and are basically incompatible with the foam washers (the heads are too small).
The foam doesn’t compress much in the center (long axis) even with the brace. I’m tempted to put a bead of silicone around the window.
Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
The photo isn’t representative of the instructions in this step. Glands aren’t shown, plate isn’t mounted. Photo shows sensor coils in place (step 7?)
1. My kit didn’t include the ring lug. I had a spare spade lug so I remade the red relay-coil wire/+red UBEC wire to look like the photo.
2. A schematic would go a long way here.
It would be nice to have a board revision # printed on the board itself. Perhaps it’s on the underside? But that’s not visible anymore since the board was installed in the previous step.
I have a February 2018 kit (shipped Feb 2, 2018) and it includes the LCD brace and foam washers. The screw heads are a different style than pictured and are basically incompatible with the foam washers (the heads are too small).
The foam doesn’t compress much in the center (long axis) even with the brace. I’m tempted to put a bead of silicone around the window.