Completed assembly on 10/12/2023. Differences I found from photos
1) Different connectors for Relay control, GFI, and Current monitors (obvious, as they can only can go one place)
2) I didn't think relay screws were self-tapping because they were hard to put in so I tapped them with 8/32 tap. Turns out they were self-tapping, just requires lots of force
3) the two cable glands didn't fit fully into the case, used a dremel to make it work
4) I incorrectly pluged the pilot wire into the top terminal because I didn't fully pay attention to the photo. Be sure to use the bottom one as shown in the picture
Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
Completed assembly on 10/12/2023. Differences I found from photos
1) Different connectors for Relay control, GFI, and Current monitors (obvious, as they can only can go one place)
2) I didn't think relay screws were self-tapping because they were hard to put in so I tapped them with 8/32 tap. Turns out they were self-tapping, just requires lots of force
3) the two cable glands didn't fit fully into the case, used a dremel to make it work
4) I incorrectly pluged the pilot wire into the top terminal because I didn't fully pay attention to the photo. Be sure to use the bottom one as shown in the picture