Skip to main content

Tools

No tools specified.

  1. Remove the EV simulator components from packaging Remove the EV simulator components from packaging
    • Remove the EV simulator components from packaging

  2. Solder resistors in place matching the values with a silk screen using a multimeter. Trim excess leads. Solder the diode in place matching the stripe on the diode with a stripe on the silk screen. Trim excess leads.
    • Solder resistors in place matching the values with a silk screen using a multimeter. Trim excess leads.

    • Solder the diode in place matching the stripe on the diode with a stripe on the silk screen. Trim excess leads.

  3. Solder the 4 positions switch with the numbers at the top. Solder the screw terminal to the board with the openings for the wire facing out.
    • Solder the 4 positions switch with the numbers at the top.

    • Solder the screw terminal to the board with the openings for the wire facing out.

Finish Line

3 other people completed this guide.

Christopher Howell

Member since: 07/05/2014

6,977 Reputation

20 Guides authored

2 Comments

Does this kit work with charging stations with type 2 (IEC 62196) plug?

For example Webasto Pure 2.

Matti Piispanen - Reply

Dear all,

Is the diode shunt between GND and Pilot? Or is it in series with the various resistors?

Thanks,

Peman

Peman Montazemi - Reply

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 3

Past 30 Days: 32

All Time: 8,222