Difficulty
Moderate
Steps
8
Time Required
- Services - EmonCMS 8 steps
Featured Guide
This guide has been found to be exceptionally cool by the site's staff.
Introduction
Outline what you are going to teach someone how to do.
-
-
Setup Free account at: OpenEVSE Energy Monitoring
-
Enter Username, Email and Password to register for an Account.
-
-
-
Click on Inputs
-
Select New Device
-
In devices already exist click the gear icon on an existing device.
-
Enter Node (0 - 32).
-
This will be used later in the WiFi module.
-
Enter name and location.
-
Select Initialize the Initialize again.
-
Click the gear icon click new and copy the device key.
-
-
-
Login the the OpenEVSE WiFi portal and click on the Services tab.
-
Click "Enable EmonCMS" in the services tab.
-
Verify the server is set to: data.openevse.com/emoncms
-
Select https:// for the server if available to enable secure mode.
-
Set node (0 - 32) Matching the value chosen in the last step.
-
Paste the Device Key from EmonCMS to write-apikey.
-
Click Save
-
-
-
Go back to OpenEVSE Energy Monitoring
-
Select Inputs - Navigate to Setup => Inputs. The Inputs section should now display live data from OpenEVSE.
-
Inputs from other sensors can be included such as additional current, temperature, humidity, voltage etc. See Open Energy Project
-
Inputs displays live data from the sensors. This data is not stored, logged or archived.
-
-
-
Dashboards display data logged from the feeds. You can create as many dashboard views as you wish.
-
Click on the Dashboard icon and click New + to create your first Dashboard.
-
The name can be edited by clicking on the pencil icon.
-
-
-
Select Widgets (Speedometer dial) then select dial.
-
Click on grid to place the dial. Move, re-size and adjust as desired.
-
Click On the wrench icon to "Configure selected item"
-
Select Feed - Set Max Value - Set Units - Pick Type
-
-
-
Add Rawdata charts for current and temprature. Click on Bargraph icon Visualizations then Rawdata. Click on the grid to add.
-
Click Wrench Icon to Configure selected item.
-
Select Feed, Color and Units
-
Move and scale as desired.
-
Save Changes
-
-
-
Add Text Labels
-
Feed values can be displayed. Click Widget > Feedvalue
-
Cancel: I did not complete this guide.
15 other people completed this guide.
5 Comments
Please note if connecting to a v5 board the pinouts are https://github.com/OpenEVSE/OpenEVSE_PLU...
Does the EVSE AP username and password need to be changed? Is the AP still accessable after I get the WiFi module connected to my home network? If the WiFi at my house goes down for some reason can someone connect to the openevse AP?
Step 2.2 has pins 4 and 5 reversed on the picture. I believe the description on the step on the right side is correct. The actual shipped connector has them in this sequence: BLACK, RED, GREEN, YELLOW. On your pic it's ...YELLOW, GREEN.
